DieselShip's Online Content Library

Q3: A. Sketch and describe a pneumatic control system for controlling temperature of main engine lubricating oil outlet of the cooler; B. Explain why air supplied to the pneumatic control system must be free from dust and water; C. Describe how above impurities are removed; State the consequences if the air supplied is contaminated

Q2. Explain why the following problems occur in turbocharger nozzles, shrouds and blades, their effects on turbocharger operation and remedies: – A. Build-up of deposits; B. Hot corrosion; C. Erosion

Q8. Describe the method of setting the safety valves of an exhaust gas boiler at sea. A. State the limits in terms of percentage above maximum design working pressure for setting safety valves. B. State the formality necessary when Chief engineer sets the safety valves

Q5. A. As 2nd Engineer describe the procedure involved in the complete inspection of a cylinder liner and piston assembly, indicating areas of significant interest; B. Explain with reasons possible faults which might be found; C. Suggest how such faults might be avoided.

Q9. Describe in detail the causes and conditions that; A. Create an explosive atmosphere in a crankcase; B. Initiate a primary explosion. C.  Propagate a secondary explosion; State how hazardous conditions can be avoided.

Q9. a). If an auxiliary diesel generator over-speeds and runs away while off the load, explain: - i. How it can be stopped,

ii. What is likely to be the reasons for the failure.

b). Give-details of what cheeks are made after the machine has been stopped:

 (i) Mechanically,                            (ii) Electrically.

Q2. During a routine crankcase inspection a main engine top end bearing is found to be wiped and subsequent inspection shows that the pin is badly scored.

A. Explain in detail the action which should be taken to enable the engine to be safety operated so that the vessel may reach a port where effective repair facilities are available.

B. State with reasons the factors which influence the speed at which the engine may be safely operated.

Q2. Sketch a Main Engine air starting distributor and describe how it operates.

List the safety devices and interlocks incorporated in main engine air starting system and state the purpose of each.

Q7. With reference to the 4-stroke medium speed engines:

A. Define the cause and effect of thermal stressing in cylinder Heads, liners and pistons.

B. Explain why thermal stressing are aggravated with increase in cylinder bore.

C. Explain how stress concentration and its effects are relieved by maintenance and operational practices.