DieselShip's Online Content Library

Q5. With reference to electronic control systems A. Draw a simple block diagram for temperature control B. Describe each component shown in the diagram in (a).

Q3. Compare methods of obtaining speed regulation of three-phase induction motor generally used in tankers by means of:

A. Rotor resistance; B. Cascade system; C. Pole-changing.

Give examples where each system may be employed with advantage.

Q4. With reference to a 3 speed a.c. cage motor driven cargo winch:

A. Sketch a circuit diagram for a pole change motor;

B. Describe how speed change and braking are achieved.

Q1. What is a marine high voltage system? Sketch and describe a shipboard high voltage switch board and its protective devices.

Q3. Differentiate between half and full wave rectification. State where half wave rectification may be used and the purpose for which it is not well adapted. Sketch a bridge connection by which full wave rectification may be obtained.

Q6. A. Explain what is meant by the terms wave form, frequency and average value.

B. A moving coil ammeter, a thermal ammeter and a rectifier are connected in series with a resistor across a 110 V sinusoidal a.c. supply. The circuit has a resistance of 50 to current in one direction and, due to the rectifier, an infinite resistance to current in the reverse direction. Calculate:

(i) The readings on the ammeters; (ii) The form and peak factors of the current wave.

Q8. A. Why is it important to maintain high efficiency of operation?  And low values of voltages regulation for power transformers?

B. A 100 KVA transformer has 400 turns on the primary and 80 turns on the secondary. The primary and secondary resistances are 0.3 and 0.01 respectively, and the corresponding leakage reactance’s are 1.1 and 0.035 respectively. The supply voltage is 2200 V. Calculate:

(i) The equivalent impedance referred to the primary circuit;

(ii) The voltage regulation and secondary terminal voltage for full load having a power factor of (i) 0.8 lagging and (ii) 0.8 leading.

Q9. A. List the factors that determine the starting torque of the three-phase induction motor. How does this torque generally compare with the value of the rated torque?

B. The low-voltage release of an a.c. motor-starter consists of a solenoid into which an iron plunger is drawn against a spring. The resistance of the solenoid is 35 ohm. When connected to a 220 V, 50 Hz, a.c. supply the current taken is at first 2A, and when the plunger is drawn into the “full-in” position the current falls to 0.7 A. Calculate the inductance of the solenoid for both positions of the plunger, and the maximum value of flux-linkages in weber-turns for the “full-in” position of the plunger.

Q6. A. With the aid of delta and star connection diagrams, state the basic equation from which   delta – star – delta conversion equation can be derived.

B. Three batteries A, B and C have their negative terminals connected together, between the positive terminals of A and B there is a resistor of 0.5 ohm and between B and C three is a resistor of 0.3 ohm,

i. Battery A 105 V, Internal resistance 0.25 ohm’

ii. Battery B 100 V, Internal resistance 0.2 ohm

iii. Battery C 95 V, Internal resistance 0.25 ohm

Determine the current values in the two resistors and the power dissipated by them.

Q10. A. Compare the effectiveness of a current limiting circuit breaker with that of a HRC fuse.

B. A coil having a resistance of 10 Ohm, and an inductance of 0.15 H is connected in series with a capacitor across a 100V, 50Hz supply. If the current and the voltage are in phase what will be the value of the current in the circuit and the voltage drop across the coil?