DieselShip's Online Content Library

Q3. A. Give a brief outline of the care maintenance that should be given to the stator and rotor of an A.C. generator;

B. Explain what is likely to occur if the driving power of one A.C. generator suddenly fails when two generators are running in parallel. What safety devices are usually provided for such events?

Q3. Compare methods of obtaining speed regulation of three-phase induction motor generally used in tankers by means of:

A. Rotor resistance; B. Cascade system; C. Pole-changing.

Give examples where each system may be employed with advantage.

Q4. A. Explain how the efficiency and regulation of a transformer can be assessed by open circuit and short circuit tests?

B. What is meant by equivalent resistance?

Q4. With reference to a 3 speed a.c. cage motor driven cargo winch:

A. Sketch a circuit diagram for a pole change motor;

B. Describe how speed change and braking are achieved.

Q5. With reference to the condition monitoring of electrical machinery:

A. State TWO important parameters that may be recorded;

B. Explain how the parameters are measured and what defects may be revealed.

Q6. A. Describe the effect of the following loads on power factor: -

(i) Induction motors; (ii) Transformers; (iii) Partly loaded motors; (iv) Cage type motors.

B. In a 50-Kav, star-connected, 440-V, 3-phase, 50-Hz alternator, the effective armature resistance is 0.25 ohm per phase. The synchronous reactance is 3.2 ohm per phase and leakage reactance is 0.5 ohm phase. Determine at rated load and unity power factor:

(a) Internal e.m.f Ea (b) no-load e.m.f E0 (c) percentage regulation on full-load (d) value of synchronous reactance which replaces armature reaction.

Q7. A. By means of a schematic circuit diagram illustrate the peak rectifier. If the supply voltage is v(t) = Vm Sin wt, what is the voltage across the load resistor?

B. A battery-charging circuit is shown below in Fig. The forward resistance of the diode can be considered negligible and the reverse resistance infinite. The internal resistance of the battery is negligible. Calculate the necessary value of the variable resistance R so that the battery charging current is 1.0 A.

Q8. A. Why is it important to maintain high efficiency of operation?  And low values of voltages regulation for power transformers?

B. A 100 KVA transformer has 400 turns on the primary and 80 turns on the secondary. The primary and secondary resistances are 0.3 and 0.01 respectively, and the corresponding leakage reactance’s are 1.1 and 0.035 respectively. The supply voltage is 2200 V. Calculate:

(i) The equivalent impedance referred to the primary circuit;

(ii) The voltage regulation and secondary terminal voltage for full load having a power factor of (i) 0.8 lagging and (ii) 0.8 leading.

Q9. Explain What is meant by, and the significance of, four of the following terms.

I. Voltage Stabilization,

II. Filter choke;

III. Impedance,

IV. Rectification,

V. Grid bias voltage.

Q7. A. Which of the following three motors has the poorest speed regulation: shunt motor, series Motor or cumulative compound motor? Explain.

B. A 440V shunt motor takes an armature current of 30A at 700 rev/min. The armature resistance is 0.7ohm. If the flux is suddenly reduced by 20 per cent, to what value will the armature current rise momentarily? Assuming unchanged resisting torque to motion, what will be the new steady values of speed and armature current? Sketch graphs showing armature current and speed as functions of time during the transition from initial to final, steady-state conditions.