DieselShip's Online Content Library

Q1. With regard to care of lubricating oils onboard, answer the following:

(a)  Microbial degradation of lubricating oil and measures to prevent the same

(b)  Methods of ensuring correct sampling is done for the purpose of shore based testing.

(c)  If the shore based testing results show an abnormal values of water content and TBN for the crank case lub oil of a slow speed main engine, what will be interpretation and subsequent action?

Q2. Cast iron is most widely used metal after steel in Marine Engineering. Most cast irons consist of graphite in steel like matrix. Discuss the variation of properties that may arise with reference to pearlitic grey cast iron and spherical grey cast iron. Describe briefly the treatment necessary to produce these two types of Irons.

Q3. With respect to the properties of fuel oil, explain the significance of the following terms.

(a) Calculated Carbon Aromaticity Inbox (CCAI).

(b) Open flash point and Closed flash point.

(c) The importance of Sodium to Vanadium Ratio.

(d) Octane Number.

Q9. With reference to Vacuum Sewage System

(a) Sketch & Describe a Vacuum Sewage System.

(b) State the advantages of Vacuum Sewage System.

(c) State the different causes of dropping vacuum.

Q6. With regards to main transmission shaft flange coupling arrangements:

A. Sketch a hollow type coupling bolt and the hydraulic head/nut and loading rod which are used to fit it.

B. Describe how the bolt is fitted.

C. State the advantage of the hollow coupling bolt as compared to the traditional type of coupling bolt.

Q5. With respect to refrigeration gases used on-board vessels, answer the following:

A. Explain Ozone Depleting Potential (ODP) and Global warming potential (GWP) of conventional refrigerant gases.

B. Name the alternate refrigerant gases available and being used onboard.

C. Explain the steps you will take to ensure that release of refrigerant gases from the plant in minimized during normal operation and during maintenance activities.

Q1. As second engineer onboard a tanker, describe the procedure for presenting a Main Boiler for survey by a classification society?

Q8. Detail the desirable properties of a refrigerant. Make a table and compare following refrigerants for use in a provision cooling plant for a 50000 DWT Oil tanker: R-22, R-134a.

Q1. Sketch a sealing arrangement for an oil-lubricated stern tube. Identify the common forms of seal failure; State how oil loss due to seal failure can be restricted whilst on passage? What is the material used for sealing rings and propeller shaft liner?