DieselShip's Online Content Library

Q1. With reference to membrane tanks for the carriage of liquefied gas at very low temperatures. A. Describe with a sketch one method of building up the insulation; B. State which alloy is used for the membrane and the reason; C. Describe with the aid of a sketch, how the tanks are located and supported. i) Longitudinally; ii) Transversely

Q3: With reference to dry docking, define the responsibility of the second engineer;

A. Prior to docking;

B. Whilst the vessel is in dry dock;

C. Prior to flooding and leaving the dock.

Q1. A. Sketch the cross-section of a bulk carrier with either deep or shallow double bottom showing the type of framing used;

B. Describe the corrosion problems experienced with ballast tanks;

C. state how such tanks are protected against extensive corrosion.

Q1. A. Describe the preparation necessary before the application (in dry dock) of sophisticated or approved long life coating to the underwater surface of the hull;

B. State the significance of the roughness profile.

C. List the different sophisticated costing which are available.

Q3. With regard to ship construction details for transverse watertight bulkheads: -

A. State the purpose of this type of bulkhead;

B. State how the bulkheads are tested for water tightness;

C. If it is necessary to penetrate the bulkhead, precaution must be taken to ensure that the watertight integrity and the strength of the bulkhead is maintained. In view of above, describe, using simple sketches, how the following pass through bulkheads.

i. Main transmission shaft;                ii. Electrical cables;

iii. Fuel oil transfer pipes;                iv. Air and sounding pipes.

Q6. A. Describe how water tightness is maintained where bulkheads are pierced by longitudinal beams or pipes.

B. A triangular bulkhead is 7 m wide at the top and has a vertical depth of 8 m.  Calculate the load on the bulkhead and the position of centre of pressure if the bulkhead is flooded with sea water on only side:

(i) to the top edge,               (ii) with 4 m head to the top edge.

Q7. Describe the procedure adopted for the speed trials of a ship and analysis of the results. What are the precautions to be taken?

Q8. What do you understand by the effective power of a ship? Describe the stages by which the power produced by the main engine of the ship is transformed into the effective power. Discuss the essential sea trials maneuvers (navigation trials) conducted and typical objectives of each test.