DieselShip's Online Content Library

Q7. An Auxiliary boiler is periodically unattended and equipped with alarms to cover low water level, high steam pressure, and air and flame failure.

A. State why and how fuel the burners are automatically cut off under alarm conditions of water level, steam pressure, air and flame failure.

B. Describe how and when each of the above alarms is tested without endangering the boiler.

Q7. A. Describe the survey procedure of an oil lubricated stern bearing and shaft. B. Explain how the integrity of the outboard seal of an oil lubricated stern tube may be proved before the dry-dock is flooded.

Q7. Fatigue is one of the main causes of crankshaft failure - A. Indicate on a sketch the most likely location of a fatigue crack; B. Explain how a fatigue failure is identified; C. Describe how a fatigue crack may be initiated; D. Describe, with the aid of sketches, the methods used to inhibit fatigue cracks.

Q4. An auxiliary engine exhibits a tendency to hunt to such an extent that the engine speed variation prohibits the connection of the machine to the switchboard. A. Discuss the possible causes of hunting; B. Explain how the problem of hunting can be rectified.

Q8. For a fully automatic provisions refrigeration system incorporating a number of rooms; A. Explain how each room temperature is set;  B. Describe the sequence of events following a demand for increased refrigerant flow from one room;  C. State with reasons the devices incorporated into the system to protect the machinery and equipment against malfunction;  D. State how satisfactory operation of the plant can be established?

Q5. With reference to air receivers and bottles explain with reasons: A. Why regular systematic internal inspection is advisable? B. Which internal areas of large receivers should receive particularly close examination? C. How bottles are inspected internally and what parts should be closely examined? D. How the condition of a bottle or receiver that cannot be inspected internally is checked?

Q7. With regard to the carriage of crude oil and its associated products: A. State the dangers involved; B. Sketch and describe the peration of an explosive meter suitable for testing pump rooms or tanks.

Q8. With respect to hydraulic Ram steering gears;

A. What emergency locking device can be used in order to speedily bring the steering gear to rest? State one reason the best angular position to lock the steering gear.

B. Use a simple sketch to show where the “Jumping” (top) and wear down (bottom) rudder carrier ring clearances can be measured. Indicate what clearances you would expect with a new steering gear;

C. State the consequences of the wear down clearances being reduced to less than Zero.

Q4. Accidents regularly occur due to premature or accidental release of CO2 into machinery spaces. With reference to this, enumerate the procedure or arrangement that you as second engineer would adopt with respect of the following

A.  Contractors working on CO2 system;

B. Understanding between bridge and engine room in the event of a machinery space fire;

C. Familiarizing staff with the system;

D. Checks and tests are carried out before putting system in operation?