DieselShip's Online Content Library

Q3. A. With reference to the underwater surface of a ship’s hull; i. Describe a hull plate roughness analyser system;

ii. State the significance of the roughness profile and compare the typical roughness values for a new ship and a ship eight years old;

B. Which reference to the application of self-polishing paint in dry dock - i. Describe the plate preparation necessary;

ii. State the defects that may occur in the paint coating if it is not correctly applied.

Q1. With reference to membrane tanks for the carriage of liquefied gas at very low temperatures. A. Describe with a sketch one method of building up the insulation; B. State which alloy is used for the membrane and the reason; C. Describe with the aid of a sketch, how the tanks are located and supported. i) Longitudinally; ii) Transversely

Q4. Describe a forced ventilation system for the machinery spaces and a natural ventilation system for a lower hold. Why hold ventilation is considered necessary?

Q7. With respect to trim and stability, describe the following - A. Effects on centre of gravity of slack tanks; B. Effect on stability of ice formation on superstructure; C. Effects of wind and waves on ship’s stability; D. Effect of water absorption by deck cargo and retention of water on deck.

Q4. With reference to the prevention of hull corrosion discusses:

A. Surface preparation and painting of new ship plates.

B. Design of the ships structure and its maintenance. C. Catholic protection by sacrificial anodes, of the internal and external areas of the ship.

Q6. A box-shaped pontoon is 36 meters long, 4 meters wide and floats in salt water at drafts F-2.00m, A-4.00m. Find the new drafts if the pontoon now passes into fresh water.

Q7. A. Explain how to distinguish between list and loll and describe how to return the ship to the upright in each case. B. A ship 120m long has a light displacement of 4000 tonne and LCG in this condition 2.5m aft of midships.  The following items are then added:

Using the following hydrostatic data, calculate the fine draughts:

Q8. A. Explain how the distribution of masses affects rolling and pitching

B.A ship turns is a circle of radius 100 metres at a speed of 15 knots. The GM is 2/3 metres and BG is 1 metre. If g = 981 cm/sec2 and 1 knot is equal to 1.8532 Km/hour, find the heel due to turning.

Q7. A. Describe the effect of cavitation’s on the propeller blades.

B. A propeller 4.6m diameter has a pitch of 4.3m and boss diameter of 0.75. The real slip is 28% at 95 rev/min. Calculate the speed of advance, thrust and thrust power.

Q8. A. Describe the stability requirements of a ship for dry-docking.

B. A ship 130m long displaces 14000 tonne when floating at draughts of 7.5m forward and 8.10m aft. GML – 125m, TPC – 18,LCF-3m aft of midships. Calculate the final draughts when a mass of 180 tonne lying 40m aft of midships is removed from the ship.