DieselShip's Online Content Library

Q1. Describe the relationship between frictional resistance and

(a) Ship’s speed;

(b) the wetted area;

(c) surface roughness;

(d) The length of the vessel.

Q2. With reference to Roll-on Roll-off ferries –

A. Describe the problem of free surface effect;

B. Explain how it is intended that water should be cleared from car or cargo decks;

C. Describe possible methods for improving the stability and survivability of these vessels.

Q3. (a) Considering the vessel as a compound beam define Bending moment shearing force. Which is the point of Maximum Bending Moment?

(b) Sketch and Describe Hatch coaming of a large bulk carrier.

Q4. With reference to the prevention of hull corrosion discusses:

A. Surface preparation and painting of new ship plates.

B. Design of the ships structure and its maintenance. C. Catholic protection by sacrificial anodes, of the internal and external areas of the ship.

Q5. With reference to Container Ships :

(a) Describe the problem of Parametric Roll ;

(b) Explain how this problem is suitably addressed in the design and operation of the vessel.

(c) Describe possible methods for improving the stability of these vessels.

Q6. A. Describe how water tightness is maintained where bulkheads are pierced by longitudinal beams or pipes.

B. A triangular bulkhead is 7 m wide at the top and has a vertical depth of 8 m.  Calculate the load on the bulkhead and the position of centre of pressure if the bulkhead is flooded with sea water on only side:

(i) to the top edge,               (ii) with 4 m head to the top edge.

Q7: An oil tanker 160m long and 22m beam floats at a draught of 9m in seawater. Cw is 0.865. The midships section is in the form of a rectangle with 1.2m radius at the bilges. A midships tank 10.5m long has twin longitudinal bulkheads and contains oil of 1.4 m3/t to a depth of 11.5m. The tank is holed to the sea for the whole of its transverse section.  Find the new draught.

Q8: A. What is meant by the Admiralty Coefficient and the Fuel Coefficient?

B. A slip of 14900 tonne displacement has a shaft power of 4460 Kw at 14.55 knots. The shaft power is reduced to 4120 kW and the fuel consumption at the same displacement is 541 kg/h. Calculate the fuel coefficient for the ship.

Q9. The ½ ordinates of a water plane at 15m intervals, commencing from aft, ar. 1, 7, 10.5, 11, 11, 10.5, 8, 4 and 0m. Calculate:

(a). TPC;

(b). Distance of the centre of flotation from midships.

(c). Second moment of area of the water plane about a transverse axis through the centre of flotation.

Q10. a) Describe the various resistances acting against the motion of the ship?

The following data are available from the hydrostatic curves of a vessel.

Calculate the TPC at a draught of 5.05m.