DieselShip's Online Content Library

Q1. (a) If soon after joining as a second engineer on a motor vessel, you observed that number of holding down bolts are slack and fretting has occurred in the area of slack holding down bolts. Describe what actions do you take.

(b) Explain the correct procedure for checking the holding down bolts tightness?

Q6. Under Continuous survey of machinery (CSM) bottom end bearing of a large 2stroke slow speed engine is due for survey.

A. As second engineer, explain the procedure involved in complete inspection of a bottom end bearing.

B. List the precaution to be taken.

C. Indicate the reasons for possible defects which could be encountered and state how they may be rectified.

D. What test are carried out on completion of survey and re-assembly.

Q3. Sketch and describe any THREE methods used to prevent the distortion of ship’s plates and frames during major welded hull repairs in dry dock.

Q6. With Reference to Main Engine Fuel Pumps.

(a) Explain how the setting of a variable injection timing fuel pump is checked and adjusted.

(b) State why it may be necessary to adjust the settings of a variable injection timed fuel pump.

Q7. Briefly describe your action plan on following exigencies:

A. Leaky economizer tube, while at sea;

B. Leaky intercooler of main air compressor, while manoeuvring.

Q3. (a) With the aid of a simple sketch, explain the “trouble spots” in a basic air-conditioning unit and with reference to your sketch, explain the following: -

(a). How the problem of increase in humidity of cooled air is overcome?

(b). How discomfort caused by the excessive drying effect of heated air is overcome?

Q7. What is Rocking test of Deck Crane? Explain the procedure of rocking test. Tabulate and indicate fault finding procedure. What is the action taken if deviation is out of limit?

Q8. With respect to hydraulic Ram steering gears;

A. What emergency locking device can be used in order to speedily bring the steering gear to rest? State one reason the best angular position to lock the steering gear.

B. Use a simple sketch to show where the “Jumping” (top) and wear down (bottom) rudder carrier ring clearances can be measured. Indicate what clearances you would expect with a new steering gear;

C. State the consequences of the wear down clearances being reduced to less than Zero.

Q9. Severe engine vibration has recently become evident when the main engine for which you are responsible operates within a certain speed range –

A. State, with reasons, the possible causes of such vibration;

B. State the consequences of operating the engine under such vibratory conditions;

C. Describe the procedure you, as Second Engineer, would implement in order to investigate and rectify the problem.