DieselShip's Online Content Library

Q1. What is understood by risk on board ship? As a 2nd engineer discuss various methods for hazard identification and assessment of risk available on board.

Q6. Under Continuous survey of machinery (CSM) bottom end bearing of a large 2stroke slow speed engine is due for survey.

A. As second engineer, explain the procedure involved in complete inspection of a bottom end bearing.

B. List the precaution to be taken.

C. Indicate the reasons for possible defects which could be encountered and state how they may be rectified.

D. What test are carried out on completion of survey and re-assembly.

Q6. A. State the circumstances owing to which it may be necessary to renew a cylinder liner.

B. Explain how the liner is removed

C. Explain how the new liner is fitted; State the important checks to be made before and after fitting.

Q7. Describe the procedure to be undertaken when, upon a routine schedule for changing fuel injectors on a main engine, It is found that the injector body is seized and cannot be removed by conventional means. How to ascertain whether the cylinder head injector can be used satisfactorily.

Q8. Explain how EACH of the following hull defects should be dealt with;

(a) A cracked weld;

(b) A severe indentation in way of a frame;

(c) Surfaces suffering from general corrosion although the extent of wastage does not warrant plate replacement;

(d) A bilge keel fractured at the forward end.

Q6. A. Describe the survey procedure of an oil lubricated stern bearing and shaft. (8)

B. Explain how the integrity of the outboard seal of an oil lubricated stern tube may be proved before the dry-dock is flooded. (8)

Q7. A. With the aid of a simple sketch, explain the operation of a basic air-conditioning unit. B. With reference to your sketch, explain the following: - i. How the problem of increase in humidity on cooled air is overcome; ii. How discomfort caused by the excessive drying effect of heated air is overcome. C. Explain how a psychometric chart is used to check conditions.

Q8. For a fully automatic provisions refrigeration system incorporating a number of rooms; A. Explain how each room temperature is set;  B. Describe the sequence of events following a demand for increased refrigerant flow from one room;  C. State with reasons the devices incorporated into the system to protect the machinery and equipment against malfunction;  D. State how satisfactory operation of the plant can be established?

Q7. Fatigue is one of the main causes of crankshaft failure - A. Indicate on a sketch the most likely location of a fatigue crack; B. Explain how a fatigue failure is identified; C. Describe how a fatigue crack may be initiated; D. Describe, with the aid of sketches, the methods used to inhibit fatigue cracks.