DieselShip's Online Content Library

Q1. With regard to NOx control requirements of Annex VI:

(a)  Explain Tier I, Tier II and Tier III requirements.

(b) Briefly explain NOx technical code and NOx Technical file. What entries are required to make in onboard NOx Technical file.

(c) The control of diesel engine NOx emissions is achieved by what means?

(d) Explain with a simple sketch any two systems for NOx emission reduction.

Q2. A. Describe the procedure to be adopted for the inspection of a safety valve fitted to an exhaust gas fired auxiliary boiler stating, with reasons, which parts should receive particularly close attention.

B. Describe the procedure for the setting of safety valves of exhaust gas operated auxiliary boilers;

C. Explain the required action a watch-keeping engineer should take after the setting of safety valves as in (B)

Q3. With respect to the properties of fuel oil, explain the significance of the following terms.

(a) Calculated Carbon Aromaticity Inbox (CCAI).

(b) Open flash point and Closed flash point.

(c) The importance of Sodium to Vanadium Ratio.

(d) Octane Number.

Q4. Describe with a sketch a pneumatic relay and show how feedback can be achieved when such a relay is used in conjunction with a flapper mechanism.

Q9. With reference to fatigue of engineering components:

A. Explain the influence of stress level at cyclical frequency on expected operating life.

B. Explain the influence of material defects on the safe operating life of engineering component.

C. State the factors which influence the possibility of fatigue cracking of an auxiliary boiler feed water pump shaft and explain how the risk of such cracking can be minimized.

Q6. With reference to electro-hydraulic steering gears:

A. Explain in terms of control parlance, the function of the “Hunting gear”;

B. Explain the consequences if the standby pumping unit is motored;

C. State TWO methods employed to prevent the standby hydraulic pump being motored by the operating unit.

Q5. With respect to refrigeration gases used on-board vessels, answer the following:

A. Explain Ozone Depleting Potential (ODP) and Global warming potential (GWP) of conventional refrigerant gases.

B. Name the alternate refrigerant gases available and being used onboard.

C. Explain the steps you will take to ensure that release of refrigerant gases from the plant in minimized during normal operation and during maintenance activities.

Q8. Explain how the ingress of sea water is prevented in an oil lubricated stern bearing system. Should the system fail, describe the corrective action possible whilst the vessel is afloat. State why two stern bearing oil header tanks are fitted in some instances?

Q9. With reference to multi-tubular heat exchangers explain:

(A) How and where impingement attack is likely to occur in the tubes

(B) Why is it desirable that coolant flow rate should not exceed that required to maintain correct fluid temperature

(C) Ample well-shaped water boxes and smooth tube inlets are desirable

(D) Partial obstruction of tube bore is a common cause of tube failure