DieselShip's Online Content Library

Q5. With respect to refrigeration gases used on-board vessels, answer the following:

A. Explain Ozone Depleting Potential (ODP) and Global warming potential (GWP) of conventional refrigerant gases.

B. Name the alternate refrigerant gases available and being used onboard.

C. Explain the steps you will take to ensure that release of refrigerant gases from the plant in minimized during normal operation and during maintenance activities.

Q6. Sketch and describe a “fail safe steering gear” suitable for use on a tanker of more than 100,000 T dwt; Explain the sequence of events that take place when an oil leak takes place in one of the hydraulic pipe lines.

Q1. With regard to care of lubricating oils onboard, answer the following:

(a)  Microbial degradation of lubricating oil and measures to prevent the same

(b)  Methods of ensuring correct sampling is done for the purpose of shore based testing.

(c)  If the shore based testing results show an abnormal values of water content and TBN for the crank case lub oil of a slow speed main engine, what will be interpretation and subsequent action?

Q2. State with reasons, how cracking in EACH of the following location is caused, rectified and avoided

a. “A”-frame.    b. Bedplate longitudinal girder.            c. Bed plate transverse girder.

Q2. Describe how you, as a Second Engineer, would prepare an auxiliary boiler for survey by a classification society.

Q6. With reference to feed regulation: A. Describe, with the aid of sketches, the operation of a boiler feed water regulator controlled by at least two other parameters besides water level in the drum; B. Give reasons for the inclusion of the other elements besides water level in controlling feed flow; C. Deduce the possible effects on the system when the drain valve in the constant leg in the level transmitter starts to leak.

Q4. Sketch a sealing arrangement for an oil lubricated stern tube.

a) Identify the common forms of seal failure. (6)

b) State how oil loss due to seal failure can be restricted whilst on passage. (5)

c) What is the material used for sealing rings and propeller shaft liner? (5)

Q4. A. State the laboratory tests that may be carried out on specimens of steel for ships’ plate giving reasons for the tests.

B. The basic compositions of two ships’ plates are given in Table below one is an example of modem practice whilst the other is a specification of a 1940’s tanker that split in two due to brittle fracture. Compare these two specifications critically and explain which of these two steels would be most resistant to brittle fracture

Q5. Sketch and describe the operation of a four ram electro-hydraulic steering gear system. Indicate and explain the valve positions for the operation of the system when one pump is isolated, and the unit is operating on two rams only.