DieselShip's Online Content Library

Q1. With regard to care of lubricating oils onboard, answer the following:

(a)  Microbial degradation of lubricating oil and measures to prevent the same

(b)  Methods of ensuring correct sampling is done for the purpose of shore based testing.

(c)  If the shore based testing results show an abnormal values of water content and TBN for the crank case lub oil of a slow speed main engine, what will be interpretation and subsequent action?

Q2. A. Describe the procedure to be adopted for the inspection of a safety valve fitted to an exhaust gas fired auxiliary boiler stating, with reasons, which parts should receive particularly close attention.

B. Describe the procedure for the setting of safety valves of exhaust gas operated auxiliary boilers;

C. Explain the required action a watch-keeping engineer should take after the setting of safety valves as in (B)

Q6. With reference to hydraulic system for deck machinery identify: A. The types of contamination likely to be found in hydraulic systems for deck machinery; B. The sources of such impurities; C. Means used to prevent problems with contamination; D. Possible effects of the oil contamination on the system.

Q6. With reference to electro-hydraulic steering gears:

A. Explain in terms of control parlance, the function of the “Hunting gear”;

B. Explain the consequences if the standby pumping unit is motored;

C. State TWO methods employed to prevent the standby hydraulic pump being motored by the operating unit.

Q6. A. Explain how and why the performance of reciprocating air compressor tends to “fall off” in service. B. State how “fall off” is indicated and to what extent permissible before correction; C. Describe how optimum performance is restored; D. What is the significance of clearance volume: for reciprocating air compressors.

Q3. A. Explain the causes of the formation of mill scale on steel plate. Describe the preparation necessary before the application of conventional paints to the underwater surface of the hull; C. Describe a coating scheme for the underwater hull using conventional paints.

Q6. A. Sketch a Main Engine air starting system and describe how it operates. B. List the safety devices and interlocks incorporated in such a system and state the purpose of each

Q7. With reference to auxiliary boiler safety valve:

A. Describe, with aid of a Sketch the safety valves for an auxiliary boiler;

B. Identify, with reasons, the part that require particularly close attention during overhaul;

C. Describe how the safety valves are reset after an overhaul.

Q1. A. Describe an automatic self de-sludging centrifuge suitable for dealing with fuel of density upto 1010 kg/m3 at 150C;

B. Explain how the centrifuge described in Q4 (a) is able to remove water from a fuel which has a density that is higher than that of water and state factors that may assist the operation.

C. As Second Engineer, write down the start-up procedure for the centrifuge described in Q1 (A) for the benefit of your staff;

D. State how is the problem of catalytic fines in fuel oil may be dealt with.