Q1. With reference to the protection of electric motors explain EACH of the following:
(a) Fuse back up protection (6)
(b) How a motor fitted with fuse back up protection may exceed its rated temperature without being tripped by the primary protection (6)
(c) The value of current rating at which the over current relay should be set (4)
Q2. a) State the conditions, which must be satisfied before an A.C generator can be paralleled with live bus-bars. (4)
b) i) Sketch a lamp-bright configuration for synchronizing lamps. (6)
ii) State the advantages of the lamps-bright system. (3)
iii) State the disadvantages of the lamp dark system. (3)
--- PREVIOUSLY ASKED AS ---
b) Sketch a lamp-bright configuration for synchronizing lamps. (8)
c) State the advantages and disadvantages of the lamps-bright system over lamps-darks system. (4)
Q3. (a) Sketch, the circuit diagram of an instrument used for measuring electrical insulation resistance. (8)
(b) Describe the circuit diagram sketched in (a), explaining how it operates when measuring electrical insulation resistance. (8)
Q4. a) Explain the working principle of an alkaline battery. (8)
b) Compare the alkaline battery with Lead-Acid battery. (8)
Q5. a) What is the purpose of AVR in an alternator? (6)
b) With the aid of a simple circuit diagram explain the basic working of a brushless alternator. (10)
Q6. A transformer steps down 11,000 V to 220 V and supplies a load of 10 kW at 0.8 power factor (lagging). The primary winding has resistances 50 Ω and leakage reactance 200 Ω. Find: (a) turns ratio, (b) secondary current, (c) primary current (referred to primary), (d) voltage regulation. (16)
Q7. Two batteries are connected in parallel: Battery A has EMF 10 V and internal resistance 1 Ω; Battery B has EMF 8 V and internal resistance 2 Ω. An external resistance of 5 Ω is connected across the combination. Find the current through the external resistance and through each battery. (16)
Q8. (a) List three main reasons why varnish is applied to transformer windings. (6)
(b) A wooden ring having a mean diameter of 200 mm and a cross-sectional area of 400mm2 is wound uniformly with a coil of 300 turns. If the current passed through the coil is 5A calculate the value of flux produced in the coil. (10)
Q9. A coil of resistance 10 ohm and inductance 0.1H is connected in series with a capacitor of capacitance 150pF, across a 200 V, 50 Hz supply.
Calculate:
a) the inductive reactance. (3)
b) the capacitive reactance. (3)
c) the circuit impedance. (2)
d) the circuit current. (2)
e) the circuit power factor. (2)
f) the voltage drop across the coil. (2)
g) the voltage drop across the capacitor. (2)
Username or email address *Required
Password *Required
Note: Entering wrong username in the login form will ban your IP address immediately. Entering wrong password multiple times will also ban your IP address temporarily.
Log in
Lost your password? Remember me
No account yet?
DieselShip support
Send us a message and we'll reply by email, usually within one business day.
We've logged your ticket and sent a confirmation to your email.