Q1. a) Explain how the efficiency and regulation of a transformer can be assessed by open circuit and short circuit tests? (12) b) What is meant by equivalent resistance? (4)
Q2. In a ship’s power system, the neutral on the low voltage side is not grounded, but it is mandatory to ground the neutral in high voltage systems. Discuss in detail for the above difference and with suitable sketches, explain the different earthing arrangements for HV system. (16)
Q3. a) In A.C. generators, voltage dip occurs in two stages.
i) Sketch a voltages-time graph showing the pattern of voltage dip. (4)
ii) Referring to this graph, state the reasons the effect on the electrical system of a small power installation when a large load is suddenly switched on. (4)
b) Explain EACH of the following categories of voltage control:
i) Error operated. (4)
ii) Functional. (4)
Q4. (a) Why is a synchronous motor not self-starting? What are the various ways in which it can be started?
(b) Differentiate Ge and Si diode characteristics. The reverse bias saturation current for a P-N junction diode is 1.0 µA at 300 K. Determine its AC resistance at 150 mV Forward bias. (10)
Q5. a) Describe the no-load saturation characteristics of a D.C. generator. (6)
b) A three phase, six pole, delta connected induction motor is supplied at 380 V, 60Hz. It draws a current of 45 A at a power factor of 0.85 lag. The stator losses are 4 kW and the windage and friction losses total 3 kW. It runs at . Calculate EACH of the following:
a) the rotor copper loss. (3)
b) the shaft output power. (4)
c) the shaft output torque. (3)
Q6. a) What do you understand by regenerative braking system? Give examples of two shipboard applications. (6)
b) Two earth lamps at 120 V, 15 W are used on a 110 V distribution circuit. Due to damage to a motor, the resistance of the positive line is reduced to 10 ohm and that of the negative line to 5 ohm. Find the voltage across each lamp and the extra load on the generator due to the fault. (10)
Q7. (a) With respect to the hazardous areas of tankers, explain the term flameproof (Exd) for electrical equipment. (6) (b) State the type of electrical equipment that would be protected in this way. (6) (c) List likely defects of flameproof equipment. (4)
Q8. With reference to oil monitoring of effluent from oil tanker cargo discharge: a) Describe with a sketch, the general arrangement of an oil discharge monitoring and control system. (8) b) State the inputs that are recorded. (4) c) Explain the difficulties encountered with the efficient operation of the oil monitoring system. (4) - - - PREVIOUSLY ASKED - - - With reference to oil monitoring of bilge and tanker ballast discharges: a) Describe with the aid of a sketch, the general arrangement of an oil monitoring system. (8) b) State the inputs that are recorded. (4) c) Explain the difficulties encountered with the efficient operation of the oil monitoring system. (4)
Q9. Explain the principle of port State control and give in detail the verification , the Port State Control Officer may carry out with reference to the following:
a) Emergency generator (4)
b) Auxiliary steering gear (3)
c) Lifeboat engine (3)
d) Bilge pump (3)
e) SOPEP. (3)
Username or email address *Required
Password *Required
Note: Entering wrong username in the login form will ban your IP address immediately. Entering wrong password multiple times will also ban your IP address temporarily.
Log in
Lost your password? Remember me
No account yet?
DieselShip support
Send us a message and we'll reply by email, usually within one business day.
We've logged your ticket and sent a confirmation to your email.