DieselShip's Online Content Library

Q1. (a) With respect to auxiliary boiler water level maintenance and indication, describe, with the aid of sketch’s, the sensing devices for. (i)A feed pump control; (ii) Local water level; (iii) Remote water level; (iv) Low and high water level alarms.

Q3: A. (i) Sketch a combustion gas system, suitable for inerting the cargo spaces of a vessel; (ii) Describe the operation of this system. B. State the percentage analysis by volume of the inert gas generated by the system in (A).

Q1. With regard to care of lubricating oils onboard, answer the following:

(a)  Microbial degradation of lubricating oil and measures to prevent the same

(b)  Methods of ensuring correct sampling is done for the purpose of shore based testing.

(c)  If the shore based testing results show an abnormal values of water content and TBN for the crank case lub oil of a slow speed main engine, what will be interpretation and subsequent action?

Q7. With reference to Keyless Propeller:

A. Sketch a section through a keyless sleeved propeller.

B. State the advantages of using a keyless sleeved propeller

C. State with reason, Which metal sleeve should be made for contact with the forged mild steel tail shaft?

D. State the material uses to bond the sleeve to the propeller and the general thickness of the bonding material.

Q9. With reference to fatigue of engineering components:

A. Explain the influence of stress level at cyclical frequency on expected operating life.

B. Explain the influence of material defects on the safe operating life of engineering component.

C. State the factors which influence the possibility of fatigue cracking of an auxiliary boiler feed water pump shaft and explain how the risk of such cracking can be minimized.

Q5. With respect to refrigeration gases used on-board vessels, answer the following:

A. Explain Ozone Depleting Potential (ODP) and Global warming potential (GWP) of conventional refrigerant gases.

B. Name the alternate refrigerant gases available and being used onboard.

C. Explain the steps you will take to ensure that release of refrigerant gases from the plant in minimized during normal operation and during maintenance activities.

Q2. Sketch suitable welded joints indicating the approximate plate thickness and dimensions of preparation for the following purposes - A. End plate connection to the shell of an unfired pressure vessel; B. Longitudinal seam of an unfired pressure vessel; C. Prefabricated combustion chamber for an auxiliary boiler

Q8. A. the UMS monitoring and control system of your ship has recently started to give false alarms and incorrect data printouts. State, with reasons, possible causes if the false alarms and reading are: I. Localized to a particular area of engine operation; ii. General to the engine room B. State, with reasons, the action you, as Second Engineer, would take to ensure continued safe operation of the vessel if the defects were general to the engine room. C. Explain the procedure you, as Second Engineer, would adopt in order to locate and rectify a general fault in the UMS system.

Q6. With reference to electro-hydraulic steering gears:

A. Explain in terms of control parlance, the function of the “Hunting gear”;

B. Explain the consequences if the standby pumping unit is motored;

C. State TWO methods employed to prevent the standby hydraulic pump being motored by the operating unit.