DieselShip's Online Content Library

Q6. Under Continuous survey of machinery (CSM) bottom end bearing of a large 2stroke slow speed engine is due for survey.

A. As second engineer, explain the procedure involved in complete inspection of a bottom end bearing.

B. List the precaution to be taken.

C. Indicate the reasons for possible defects which could be encountered and state how they may be rectified.

D. What test are carried out on completion of survey and re-assembly.

Q6. A. State the circumstances owing to which it may be necessary to renew a cylinder liner.

B. Explain how the liner is removed

C. Explain how the new liner is fitted; State the important checks to be made before and after fitting.

Q8. Explain how EACH of the following hull defects should be dealt with;

(a) A cracked weld;

(b) A severe indentation in way of a frame;

(c) Surfaces suffering from general corrosion although the extent of wastage does not warrant plate replacement;

(d) A bilge keel fractured at the forward end.

Q8. With respect to hydraulic Ram steering gears;

A. What emergency locking device can be used in order to speedily bring the steering gear to rest? State one reason the best angular position to lock the steering gear.

B. Use a simple sketch to show where the “Jumping” (top) and wear down (bottom) rudder carrier ring clearances can be measured. Indicate what clearances you would expect with a new steering gear;

C. State the consequences of the wear down clearances being reduced to less than Zero.

Q6. With regard to keeping the gas side of boilers in good condition discusses EACH of the following:

A. the mechanism of combustion, stating the factors which are important to good combustion;

B. Oil fuel treatments;

C. Soot removal equipment;

Q6. With reference to the circuit breaker for an a.c. generator A. Describe the preventive maintenance carried out on the circuit breaker for an A.C Generator. B. Explain the sequence of events that might occur if the breaker opens on a short circuit and state the check you would require following such event. C. Give a safe procedure to follow should a main circuit breaker fail to open under fault condition.

Q7. A. With the aid of a simple sketch, explain the operation of a basic air-conditioning unit. B. With reference to your sketch, explain the following: - i. How the problem of increase in humidity on cooled air is overcome; ii. How discomfort caused by the excessive drying effect of heated air is overcome. C. Explain how a psychometric chart is used to check conditions.

Q9. Write short note on the followings –

A. Metal – locking;

B.TIG and MIG welding;

C. Brazing;

D. Soldering.

Q9. A. With reference to the insulation testing of marine electrical plant: - I. State the reasons for insulation testing; II. State the precautions to be observed when testing intrinsically safe equipment. B. Describe the overhaul of d.c. motor which has been subjected to excessively damp condition or flooding with seawater.